НЕ знаю почему но в инструкции по установке FMPC2 они рекомендуют для установки систему XP и в ней же говорят что можно инсталировать C4\\C5
Required Tools and CDs
ROM remover or screw driver (-)
• Windows XP Professional SP1/SP2 CD
• DI Print/Data Writing Service Software [C4/C5] CD
• Insulating tape
• Print Size Set Tool Software (FD)
• “3KPrintsizeCopyTool” Software (FD)
(used only in case of FRONTIER 355/375)
Процес установки по пунктам
No. Procedures Location Refer to
1 IEEE1394 Board Installation FMPC See Section 2.2.1 on page 16
2 PC Preparations FMPC See Section 2.2 on page 16
3 Disabling of “Rack Auto Cleaning” SP See Section 2.3 on page 48
4 IEEE1394 Driver Pre-installation FMPC See Section 2.4 on page 48
5 Copying Print Size Table from SP to FD SP See Section 2.5 on page 49
6 Creating Backup FD for LP5500/5700 SP See Section 2.6 on page 50
7 Changing Mode from SP-3000 to FMPC SP See Section 2.7 on page 51
8 Connecting FMPC, FRONTIER, LAN cable and Monitor
Switcher
SP, FMPC, LP,
Monitor Switcher
See Section 2.8 on page 52
9 Turning on FRONTIER LP, SP See Section 2.9 on page 57
10 Turning on FMPC and Installing LP5500/5700 Driver FMPC See Section 2.10 on page 58
11 Installing SP-3000 Driver FMPC See Section 2.11 on page 59
12 Disabling Network Connection on SP Side FMPC See Section 2.12 on page 60
13 Installing FMPC Software [D20] FMPC See Section 2.13 on page 61
14 Copying SP-3000 Print Size Table to FMPC FMPC See Section 2.14 on page 63
15 Installing DI Print/Data Writing Software
[C4/C5] Client in FMPC
FMPC See Section 2.15 on page 64
16 Turning on Imaging Controller DIC See Section 2.16 on page 65