Попал мне в руки документик от GPE. Это "introduction" к новой процедуре настройки премаски для эпсоновских матриц.
The new boards version 3.1 and 4 or later give the possibility of apply a pre-mask by means of some signals sent to the LCD instead of the usual correction on the gamma.
The new system, described in this document, required a board revision D. It is possible to upgrade versions 3.2 and 4.0 to the new one by changing the solder jumper described in the attached document. In addition a tuning of control signals is suggested for a complete upgrade.
The new procedure brings the darker side of the print to the same densisty of the lighter one, so it makes the print lighter.The final density is not compromised but the contrast is more uniform and this helps for making better passport prints, for example.
Переводить не надо, все понятно. Но кто может поподробнее рассказать о какой "запаянной перемычке" идет речь и какой-такой "тюнинг сигнала" надо произвести чтобы достичь обещанного? И поделитесь "attached document", плиз, мне он не достался.
На железо еще не смотрел, хотелось бы перед разборкой понять что надо смотреть.