Форум проекта "Минилаб-Мастер"

Вопросы по ремонту наладке и настройке минифотолабораторий => Минилабы Gretag => Тема начата: Sesna от 15 Апреля 2017, 10:09:11

Название: Ошибки gretag master flex 1008d
Отправлено: Sesna от 15 Апреля 2017, 10:09:11
Вот такая проблема.
Появилось сообщение:
Message:Source: Wetpart
Operator Message: Films may be destroyed in case of mains power failure. (The charge of wetpart battery is low.) Printing and film processing still possible. IN CASE OF MAINS POWER LOSS THE EMERGENCY TRANSPORT OF FILM PROCESSOR WILL NOT WORK ANYMORE.
Diagnosis: The message should disappear after a few hours of recharge. If not, check if battery is charged. Maybe, the battery has to be changed. Select Setup - Printer and Wetpart - Service - Wetpart - Power Mgmt to check state of batteries.
 
Проверил и заменил акумы. После полной зарядки сообщение пропало. После рестарта снова появляется и через несколько минут исчезает. Или в процессе  работы снова может появить и исчезнуть. Раньше такого не было.

Второе сообщение:
Message:Source: Film Processor
Operator Message: Film processing is not possible. (The film processor cannot transport film.) Please make sure the film processor cover is completely closed and engaged.
Diagnosis: The film processor has signaled a transport alarm (no pulses from the speed sensor). Please be aware: The film transport motor is disconnected by the safety switch, when the film processor cover is opened. If this is not the case, check the transport motor, the fuse, the connectors and the speed sensor.

Такая же ерунда. Причем крышку закрываеш сообщение исчезает и через несколько секунд снова появляется. В ручную на датчик нажимаеш, то же самое.
Вроде все работает но сообщения напрягают. Где искать причину?