Автор Тема: Autolevel alarm for the paper stabilizer 4 electrovalve  (Прочитано 2925 раз)

0 Пользователей и 1 Гость просматривают эту тему.

Sesna

  • Бывалый
  • **
  • Сообщений: 35
  • Карма: 0
  • Пол: Мужской
  • Это Я :-)
    • Просмотр профиля
Gretag masterflex 1008d
И вот такая ошибка сама появляется и исчезает
Source: Paper Processor
Operator Message: Printing may not work properly. (Autolevel alarm for the paper stabilizer 4 electrovalve.) You may try to switch the minilab off, then on again with the green button in the front panel.
Diagnosis: Check the following points: water pump, microswitch, fuse and electrovalve paper stabilizer 4. Select Setup - Printer and Wetpart - Service - Paper Proc - Liquid - Top Off to check the related parts.

Форум проекта "Минилаб-Мастер"